CAD Challenge Submission: The License Plate Flipper by 6007X
ethankurtz
Entry ID #: 4956
Created: Tue, Jan 9, 2018 7:46 PM
Introduction: Imagine: You just finished a match and had to do maintenance on your robot. You finished fixing your robot just in time for the next match and you have 1 minute until the match starts. You now have to change out your blue license plates for red ones. Already low on time, you have to unscrew both license plates, switch them, and screw the new ones back on. License plate swaps take approximately 1 minute, so by the time you finish switching license plates, the match has already begun. We used Autodesk Inventor Professional 2017 to create the license plate flipper so we would not have to waste time switching out license plates.
